 |  |
 
Features for TFT-LCD Monitor:
- OSD (On Screen Display) control for: Color, Tint, Brightness, Control and Mirror (for Camera Mirror/Front View Switch)
- Wireless IR Remote Control
- NTSC/PAL Signal Auto Detection
- Audio Speaker is included
Features for Control Box:
- 2 Camera inputs, CCD2 is default for reverse gear operation
- 2 Audio/Video Output for tape recorder
- 2 Auto switch from CCD1 input to CCD2 input source in order to check view behind the cae (AUTOMATIC MIRROW VIEW IN MONITOR) while driver set the gear to REVERSE
- Monitor auto power on while Reverse Gear signal detected
Specifications for Model No. CC47D:
| Pick-up Device | 1/3" image sensor interline transfer CCD |
| Image Size | 4.82x3.64mm |
| Elements | NTSC: 510(H)x492(V) PAL:500(H)x582(V) |
| Horizontal Resolution | More than 380 TV lines |
| Shuter Control | NTSC: 1/60~1/100,000sec. PAL: 1/50~1/100,000sec. |
| Scanning System
| 2:1 Interlace |
| Synchronization | Internal |
| S/N Ratio | More than 48dB(AGC OFF) |
| Gain Control | AUTO |
| Sensitivity
| 0 Lux/F1.2 by IR LED |
| Video Output | Composite 1.0Vp-p/75Ohm |
| White Balance
| AUTO |
| Power Consumption | 3w (Max) |
| Dimension
| 104.6mm(D)x62mm(W)x62mm(H) |
| Weight (per unit) | 650g |
| Scanning Frequency
| H:NTSC: 15.750 KHz/PAL:15.625KHz V:NTSC:60Hz/PAL:50Hz |
| DC Power Source | DC9~12V |
| Lens Mount
| Board lens 2.5mm/F2.5 |
| Lens View Angle | 115.5 degree |
| IR LED Type | 850nm/Auto control by CDS |
| IR LED ON | Under 35~50 Lux |
| IR LED Project Distance | 5 Meters MAX |
| Operation Temperture | -10 to 50 C(14 to 122 F) |
| Storage Temperture
| -30 to 60 C(-4 to 158 F) |
| Lens Mount Type | Board lens 1.65mm F2.8|H:114 V:85 |
| Operation Temperature
| -10 to 70C(14 to 158 F) |
Specification Model CM700:
| Display | 7" active matrix TFT-LCD (16;9) |
| Back Light | Built-in CCFL |
| Dot Format | 1440(H)x234(V) |
| Dot Pitch | 0.108mm(H)x0.375mm(V) |
| Brightness | 300 cd/m2 (Nit) |
| Viewing angles
| 65/65/40/65 degrees (L/R/T/B) |
| Pixel configuration | Stripe |
| Power requirements | 12 VDC for monitor/13-24 VDC for control box |
| Video signal | 1V p-p (positive) 75 ohms. |
| Video system
| NTSC/PAL Auto Detection |
| Operating temperature | 0-50 C |
|
|